Preparation for Use
2-5
10 TEGAM WAY ● GENEVA, OHIO 44041 ● 440-466-6100 ● FAX 440-466-6110 ●
7.
At initial power on after battery replacement, allow approximately 30 seconds for
instrument to stabilize.
Figure 1: Battery Installation
Making Your First Temperature Measurement
TEGAM’s 900 Series Thermocouple Thermometers are designed for easy operation, while still
providing a feature-rich experience via the intuitive user interface.
To get started making temperature measurements right away, follow these steps:
1.
Perform Section 2.5, Battery Installation and Replacement;
2.
Connect a compatible temperature probe to the Channel 1 and/or Channel 2 input
connector located at the top of the instrument;
To ensure best measurement accuracy, allow several minutes for the
thermocouple probe and connector to thermally stabilize after
connection to the instrument.
3.
The instrument will immediately display a temperature measurement for the
connected channels. However, to ensure valid and best accuracy measurements,
continue to Step 4 below;
4.
Set the desired measurement parameters as follows:
a.
Enter the Setup Menu by pressing
, hold the key down for
approximately 1.5 seconds, and then release it;
b.
The active thermocouple type is flashing on the display. Use
to
select the thermocouple type of the connected temperature probe (E, J,
K, or T);
c.
Momentarily (do not hold) press
to save your selection and move to
the next parameter;
Retaining Screws
Battery
Compartment
Gasket
