TEFAL OptiGrill+ GC712, Инструкция по эксплуатации

Страница: 14 / 73

14
Troubleshooting guide
Problem
Cause Solution
Button
blinking
+ Indicator light solid green
+ Button blinking
• Switching on the
appliance or starting an
automatic cooking cycle
with food and without
p lates p reh eatin g
(manual mo de is
automatically activated).
• 2 possible options:
– Choose the temperature setting by
pressing the button and then
press
OK
. Allow to cook, but you must
monitor the cooking (manual mode).
– stop the appliance, remove the food,
close the appliance properly, re-
program the appliance and wait until
end of preheating.
The appliance stops during the cycle of
pre-heating or cooking.
• The appliance has been
kept open for too long
while cooking.
• The appliance has been
idle too long after the
end of warm up or keep
warm.
• Disconnect the appliance from the outlet
and leave for 2-3 mins., restart the process.
The next time you use the appliance,
make sure you open and close it quick for
best cooking results. If the problem occurs
again contact your local Tefal customer
service.
The indicator light will blink white
+ Button / / / blinking
+ Intermittent beeping
• Appliance failure.
• Appliance stored or used
in a room that is too cold.
• Disconnect and reconnect your appliance
and immediately restart a preheat cycle.
If the problem persists, contact your
Customer Service.
The device does not beep.
The indicator light will blink white
+ Button blinking
+
Continuous beeping
• Appliance failure. • Unplug the appliance and contact
customer service.
After preheating, I placed the food inside and
closed the appliance, but the indicator
light stays purple and cooking does not
begin.
• The quantity of food
inside the appliance is
greater than 4 cm.
• The quantity of food should not exceed
4 cm.
• The grill was not opened
completely when placing
the food inside.
• Open the grill completely and close it
again.
The appliance does not
detect food inside
The
quantity of food is
insufficient, " OK " is
blinking.
• Confirm cooking activation by pressing
the button .
The appliance will activate in manual mode
+
The indicator light
will blink red
.
+
button temp control and light
fixed
• Preheating time was cut
short.
• Monitor the cooking periodically
(for use in manual mode).
Or
• Stop the grill, remove food, close the grill,
select the new cooking programme you
wish to use and wait for the preheating
cycle to finish.