TEFAL INTENSE PURE AIR PU4065, Руководство пользователя

Страница: 9 / 39

9
EN
Timer / delayed start
If the appliance is on:
you can use this button to define the operating duration. Briefly press the button to select
the number of operating hours desired (1, 2, 4 or 8) and the appliance will automatically turn off at the end of the
selected period.
If the appliance is off: briefly press the button to set the appliance to turn on in a certain number of hours (1, 2, 4 or 8).
3D pure air function (adjustable grid)
You can adjust the position of the air outlet grid manually, as desired. For an optimum, even flow of purified air in
the room, set the angle to 45°; for maximum comfort, set the angle to 90°.
Control Panel Lock
The lock system prevents the purifier from being accidentally mis-set during operation.
To activate it, press the button (8) for 3 sec until the locked control panel indicator turns on. To exit this mode, press
the button (8) again for 3 seconds, until the indicator turns off. When selected, the other buttons are locked.
MAINTENANCE
Always switch the appliance off with the button (10) and unplug it before conducting any maintenance
operation.
You can clean the appliance with a slightly damp cloth.
IMPORTANT: Never use abrasive products which could damage your appliance’s appearance.
Filters
Filter Action Cycles
Pre-filter
Clean Every 2 to 4 weeks
Active carbon filter Replace Every 12 months
HEPA filter
Replace Every 3 years
NanoCaptur filter Replace
Color changing
(see Color chart on filter)
This data is based on an average use of 8 hours per day at speed 2.
The recommended frequency for cleaning and replacing the filters may vary depending on the duration of use and
the operating environment.
- The light indicates when the pre-filter needs cleaning.
- The light indicates when the active carbon filter needs replacing.
- The light indicates when the HEPA filter needs replacing.
- The light indicates when the color of the NanoCaptur filter needs checking.
• The NanoCaptur filter contains translucent granules which change color according to the formaldehyde absorption
rate. Refer to the color chart on the inside of the panel or the filter itself to establish the filter saturation rate. Once the
saturation rate has reached its maximum, the filter must be replaced. You have to check the filter saturation rate every
six months.
• The pre-filter can be re-used: remove the dust using a vacuum cleaner or wash with water.
CAUTION:
The appliance’s efficiency can be reduced if the pre-filter is not cleaned regularly.
Never use a pre-filter that is still damp.
The pre-filter is the only filter which can be re-used and washed with water. The HEPA, NanoCaptur and active
carbon filters cannot be cleaned and re-used. Never wash with water.
To replace the filters, follow the instructions in the section “Disassembling/Reassembling filters” .