STEP 8
Assemble Main Shaft to Table Bed
• Facing the front of the A-Frame, hold the Main Shaft in your left hand
with the height markings facing up. Slide the end of the Main Shaft
into the Main Shaft Housing (Figure 24), located at the base of the
Table Bed.
• With your right hand, pull out the Height-Selector Locking Pin
(Figure 25) to allow the Main Shaft to slide in further and release
in the desired height setting. Refer to the Owner’s Manual for more
information on selecting your height setting.
• The Main Shaft
MUST REST
against the Crossbar bumper on the
A-Frame (Figure 26).
IMPORTANT:
The Crossbar prevents the Table Bed from rotating
forward when the user steps on the Ankle Comfort Dial. If the
Main Shaft does not rest on the Crossbar bumper as shown in
Figure 26, then the Table Bed has been assembled backwards
onto the A-Frame.
This
MUST BE CORRECTED
before use. See also Image B on Page 14
to ensure correct assembly.
• Test the inversion table by hand for smooth and steady rotation
(Figure 27) and ensure that all fasteners are secure.
FIGURE 24
FIGURE 25
FIGURE 26
FIGURE 27
13