STEP 3
Assemble Rear Ankle Bar
• Locate the Rear Ankle Bar Assembly Hardware Kit (HK1003).
• Insert the Rear Ankle Bar into the large hole at the back of the
Main Shaft. Ensure that the embossed Ergo Embrace logo on the
preassembled Heel Cup is on top (Figure 6).
• Insert the bolt from the rear of the Main Shaft to secure the Rear
Ankle Bar (Figure 6), and fasten with the washer and nut using the
wrenches provided.
• Slide the separate heel cup, with the embossed Ergo Embrace
™
logo on top, onto the open end of the Rear Ankle Bar (Figure 6a).
TIP: To assist with assembly, repeatedly rotate the Heel Cup while
pushing it onto the Rear Ankle Bar.
• Align the pre-drilled screw hole in the Rubber Plug with the screw
hole in the Rear Ankle Bar. Insert the Rubber Plug into the open
end of the Rear Ankle Bar (Figure 7).
TIP: You may want to use a rubber mallet to assist with assembly.
• Secure the Rubber Plug with the screw using the screwdriver
provided (Figure 8). If the screw does not tighten easily, you may
need to reposition the alignment of the Rubber Plug.
8
FIGURE 6a
FIGURE 7
FIGURE 8
FIGURE 6