Teesa CUT PRO X400, Руководство пользователя

Страница: 11 / 32

Owner’s manual 11
EN
OPERATION
1. Connect the appliance to the power supply socket.
2. Push the on/off switch upwards to turn on the appliance.
3. Push the taper lever up or down to choose desired setting.
4. Start cutting your hair:
• To achieve best results it is recommended to stat trimming from the back and
bottom of the head and moving the hair clipper upwards towards the top of the
head.
• When cutting hair with a comb attached, make sure the cutter stays close to the
skin.
• Use the appliance without comb attached for more precise trim (for example on
the temples).
• The appliance has a sharp cutter. Therefore do not press the hair clipper too hard on
the skin to avoid injuries.
• Use the included comb and scissors to further style your hair. Hold the hair with the
comb and cut over the comb with the hair clipper or scissors.
5. After trimming, turn off the appliance by pushing the on/off switch downwards.
6. Disconnect the appliance from power supply socket.
7. If the appliance was used with the comb attached, remove and clean the comb and
the whole appliance according to the instructions included in “Cleaning” section.
* When the lever is set to the highest position, the stationary and moving blades are close
to each other, resulting in a short haircut. Set the lever to the lowest position to increase the
distance between the two blades and as a result achieve longer haircut.
General:
• Do not immerse the appliance in water.
• Do not clean the cutter under running water. Clean it only with the included brush.
• Do not use any abrasives or chemical agents to clean this product.
• Clean only the casing with a soft and slightly damp cloth.
• Clean the appliance after each use. Regular cleaning guarantees better shaving
performance.
1. Make sure the appliance is turned off and disconnected from power mains.
2. Use the included brush to clean the cutter.
3. Clean the combs using the brush or rinse them under running water. Make sure to
wipe them dry before refitting.
CLEANING
When hair jams in between the moving and stationary blade, push the lever up and down a
few times until hair are released.