Teesa BBQ 2000, Руководство пользователя

Страница: 15 / 56

Owner’s manual 15
EN
– when connecting/disconnecting gas cylinder, regulator and hose follow instructions
supplied with them).
The hose should be secured to the regulator and the appliance with hose clips.
• Use a suitable, certified regulator which meets all safety requirements! The use of the
wrong regulator or hose is unsafe; always check that you have the correct items before
operating the barbecue.
• The used hose must conform to the relevant standard - It should comply with the
EN16436 standard.
• The length of the hose must be 1,5 meters (maximum). Worn or damaged hose must be
replaced.
• The hose, used to connect the appliance with the LPG cylinder must be changed within
the prescribed intervals and according to the National Rules in force.
• Ensure that the hose is not obstructed, kinked, or in contact with any part of the barbecue
other than at its connection.
• The hose should not be twisted or kinked when attached to the gas cylinder.
• No part of the hose should touch any part of the appliance. Protect the hose from heat,
as it will lead to damage and is potentially dangerous!
Notes on gas cylinder
• Keep the gas cylinder at least 50 cm away from grill when using.
• The appliance can be used with gas cylinder
• weight between 4,5~15 kg (butane) and 3,9~13 kg (propane).
• maximum size: 660x320 mm
• The gas cylinder should not be dropped or handled roughly!
• If the appliance is not in use, the cylinder must be disconnected.
• Replace the protective cap on the cylinder after disconnecting the cylinder from the
appliance.
• Cylinders must be stored outdoors in an upright position and out of the reach of children.
• The cylinder must never be stored where temperatures can reach over 50ºC.
• Place the cylinder only on flat, stable and cool surfaces! Do not place the cylinder on
heated surfaces!
• Do not store the cylinder/replace near flames or other sources of ignition. DO NOT
SMOKE NEAR THE CYLINDER.
• Warning: Shut off the gas cylinder if you smell gas.
3. CHECK FOR LEAKS
1. Make leak detecting solution by mixing one part washing up liquid or liquid soap with
3 parts water.
2. Ensure the cylinder valve is turned off, and the control knobs on the appliance is OFF too.
3. Connect the regulator to the cylinder and appliance with the hose. Ensure the
connections are secure then turn the gas cylinder to ON.
4. Brush the soapy solution on to the hose and all joints. Leakage will show as bubbles. If
leak is found, do not use the barbecue – before use the leakage must be rectified.
5. Retest after fixing the fault. Turn OFF the gas cylinder valve after testing.
6. If detected leakage can not be rectified, consult your gas dealer.