Maintenance (Continued)
6. If replacing capacitor (single phase
only), remove wires from capacitor.
Remove capacitor.
Risk of electric
shock. Before
touching capacitor, discharge it by
shorting the terminals together with an
amber handled screwdriver.
7. Slide a small screwdriver up beside
the shaft and pry the lip seal (Ref.
No. 20) out. Discard lip seal after
removal. Be careful not to scratch
the shaft.
8. Remove retaining ring (Ref. No. 19)
and washer (Ref. No. 18) from
motor shaft and slide rotating half
of seal (Ref. No. 17) off of shaft.
9. Remove motor cover from seal
plate (Ref. No. 10). Remove
through bolts (Ref. No. 15) from
motor assembly (Ref. No. 8).
Remove motor and shaft from seal
plate.
10. Working from back of seal plate,
tap primary seal head out of seal
plate; thoroughly clean seat cavity.
REASSEMBLY
NOTE:
Make sure that seal faces are
clean and undamaged.
1. Apply Permatex #2 sparingly to
outside of the primary seal head.
Press new primary seal head into
cavity in seal plate, (See Figure 2).
2. Set seal plate on cradle and reinstall
motor.
NOTE:
Do not overtighten through
bolts!
3. Inspect seal plate O-Ring carefully;
replace if damaged. Place O-Ring in
groove on seal plate, mount motor
cover on seal plate with socket head
screws.
NOTE:
It is good practice to replace
O-Ring each time pump is serviced.
4. Turn assembly upside down and
slide new rotating member of seal
onto shaft. Apply soap to rubber
ring to aid in sliding seal on shaft.
NOTE:
De-burr snap ring groove
before installing seal. Do not damage
ceramic face or rubber ring when
passing seal over shaft shoulder and
snap ring groove shoulder. Seal faces
and ring must be clean and
undamaged or seal may leak, (See
Figure 3).
5. Reinstall washer and snap ring on
shaft, (See Figure 4).
6. Install new lip seal, (See Figure 5).
Lubricate lip seal with a small
amount of Aqualube or a lithium-
based grease.
7. Reassemble impeller, washer, and
impeller screw (Models 4RK45
through 4RK49).
Reassemble impeller and impeller
nut (Models 4RK62 and 4RK63).
Models 4RK45, 4RK46, 4RK47,
4RK48, 4RK49, 4RK62 and 4RK63
5
Teel Operating Instructions and Parts Manual
E
N
G
L
I
S
H
®
Impeller side of seal plate
Permatex
here
Press seal
into cavity
Figure 2
Slide
ceramic
part onto
shaft
Don't
damage
rubber ring
on groove
Figure 3
Install washer,
then clip
Figure 4
Slide seal
onto shaft
Figure 5
TABLE III – 3 Phase Wiring Connections
208-230V
460V
L1
Red
L2
Black
L3
White
L1
Red
L2
Black
L3
White
1
2
7
6
4
8
3
5
9
1
2
7
6
4
8
3
5
9
12
10
11
12
10
11
460V
L1
Red
L2
Black
L3
White
1
2
7
6
4
8
3
5
9
208-230V
L1
Red
L2
Black
L3
White
1
4
8
3
5
9
2
7
6
Stator Leads: 9 Wire
Stator Leads: 12 Wire