9
To ignite the arc mode dwutaktu must approach the electrode to the workpiece at a distance of a few millimeters, and press the button on the handle of
the torch. After the correct initiation of arc welding lead the button pressed. Releasing the handle causes us to start phase downslope and end of the
welding process.
To ignite the arc mode dwutaktu must approach the electrode to the workpiece at the distance of 2 millimeters and press the button to turn on the torch
handle ionizer. If within five seconds will not arc ignition, it will shut off automatically, and lights up the LED (18). To re-enable ionizer release button in
the handle, wait until LED (11) and press it again. After the correct initiation of arc welding lead the button pressed. Releasing the button on the handle
causes the start of the current phase of descent and ending the welding process.
To ignite the arc mode czterotaktu must approach the electrode to the workpiece at the distance of 2 millimeters and press the button on the handle of
the torch to turn the ionizer. If within five seconds will not arc ignition, it will shut off automatically, and lights up the LED (18). To re-enable ionizer
release button in the handle, wait until LED (11) and press it again. After the correct arc is lit button can be released and welding lead to the slow button.
To complete the welding press and release the button on the handle.
ATTENTION !! Do not turn on the button at a distance greater than 2 mm from the work piece. Do not touch the electrode while pressing the
button on the handle. Ionizer high voltage and the voltage in no-load condition occurring when the electrode can cause electrical shock.
12. Before calling service,
In the event of malfunction of the unit, before sending welding for service, check the list of basic failures and try to remove them yourself.
Repair work may only be carried out after removing the plug from the wall socket.
Attention! The device is not sealed, and the user can remove the cover of the welding device in order to remove minor breakdowns.
symptoms
Remedy
The control panel is not lit, the fan
does not work, no output
1. Make sure the switch is in the ON position
2. Check the security on the network connection and
3. Remove the cover and check the connection of all electrical plug inside the device
The control panel lights up, the fan
does not work, no output voltage.
1. Verify that the device has not been connected to the higher voltage. If so, connect to 230V
and turn again
2. The supply voltage is unstable and turns on the overvoltage protection. Turn off device for 2-3
minutes and then back
3. Short on and off switch may have been activated overvoltage protection. Turn off device for 2-3
minutes and then back
4. There was other damage requiring repair by an authorized service
The control panel lights up, the fan is
working, problems with arc is started
1. Check TIG replace wear parts, if they are used
The control panel lights up, the fan is
running, no strikes arc welder
1. Check the correct terminals and the electrical conductivity of the electrode wire and the mass
2. Check the connection of TIG torch to the device, pay attention to whether the socket pins are not
broken or jam.
3. Unscrew the TIG torch handle and check that the switch in the handle is OK
The control panel is lit, the fan operates,
lights up the LED (2)
1. The device is overheated. Wait a few minutes. After the indicator goes out to
continue welding.
