Tecumseh CD454532EGH-S, Руководство по установке

Страница: 9 / 24

9
To access the electrical connector, please unscrew the cover
(As shown in the picture-3)
In order that these units have the starting, operating and dependability characteristics
required of them, the compressor and its protective devices are designed for operation
within a specific minimum 90% and maximum 110% of the rated voltage. This voltage
range is defined in the following table
ELECTRICALS
Verify before any electrical installation if the voltage and phases of the supply satisfy
those required of the unit. Refer the below table for voltage code details.
Refer to “Maximum Continuous Current” to size the electrical wires, fuses and over
current protection devices.
A pump down cycle should be employed to control all these units as per the application
requirement. That is, solenoid valve for the liquid line. (Applicable for fully built models only).
Room thermostat is the scope of customer and installed by the qualified technician.
The wiring diagram shows all electrical components connected to the system. And in
case any component be added to the unit as a field supplied option then, the wiring
should follow the given wiring diagrams (shown in the page no. 10 & Affixed inside the
electrical cabinet/cover (See Picture-4)
CAUTION: Any non-compliance with voltage ranges and phase balances or any altering of
electrical components without Tecumseh written approval will void the warranty.
RATED VOLTAGE
XC
XG*
GH
GE
GF
220-240V @ 50 Hz 1 Ø
380-420V @ 50 Hz 3 Ø ; 460V @ 60 Hz 3 Ø *
230V @ 50 Hz 1 Ø
230V @ 50 Hz 1 Ø
400V @ 50Hz 3 Ø
VOLTAGE CODE
* Compressor Voltage Code: Operating frequency is 50/60 Hz but condensing
unit is compatible for 50 Hz only