Tecumseh CD454532EGH-S, Руководство по установке

Страница: 6 / 24

6
INSTALLATION INSTRUCTIONS
TO PROPERLY LOCATE THESE OUTDOOR CONDENSING UNITS, CAREFULLY
CONSIDER THESE IMPORTANT FACTORS:
UNPACKING, LIFTING/HANDLING INSTRUCTION
Weight Of The Unit. If units are installed on the roof, their weight and weight
distribution should be checked against the building specifications and the building
codes.
Distance Of The Unit to the refrigerated cabinet and power supply socket.
Space Around The Unit and in between adjacent units. This should consider
prevention of the re-circulation of the air and ensure enough airflow through the unit.
(Refer Drg.1 in page no. 4)
These distances should also provide enough room around the units so that
enclosure panels may be removed and that adequate accessibility is provided to the
compressor, electrical boxes and other controls for maintenance.
Orientation of the units should consider the prevailing wind direction. It is
recommended not to position the units in such a way that the airflow direction
through the unit faces to prevailing wind direction for the area. The units should be
mounted securely on adequate rigid and leveled bases, to avoid improper
lubrication conditions for the compressor. Never use the shipment pallet as a
permanent mounting base. If vibrations is a concern, then proper vibration insulators
should be installed under the mounting base.
Don’t remove the carton box until the unit arrives at the destination.
Verify the shipping symbols on the packing box are in right direction.
Cut the packing straps and remove the packing carton box.
(refer the Picture-1 Picture-2)
While lifting proper measures should be taken to protect the enclosure panels.
Always keep the unit upright, laying the unit on its side or top may cause
the unit damage.
Care should be taken to locate the center of gravity of the unit before lifting,
as the compressor is the heaviest part of the unit may not be located in the
center of the unit base.
Never lift or displace the units with enclosure panels removed.
A ll the panels should be in place and properly tightened.