TECHNICAL SPECIFICATION
- Voltage: 220-240 V ~
- Frequency: 50Hz/60Hz
- Power: 500 W
Ⅴ
. Common failure analysis
Common failure
Cause analysis
Solution
After power connecting,
switch it on and the Juicer
doesn’t work.
1. Center Ring was not
installed in place;
2. Top Cap was not installed in
place;
3. Microswitch broken
1. The voltage is below level;
2. Ingredients are excessive;
3. Exert excessive pressure to
press the Pusher;
4. When the motor is overheat-
ing, the motor will have protec-
tion.
1. Juicing Sieve broke;
2. Much pomace accumulated in
Center Ring.
1. Much pomace accumulated in
Center Ring;
2. Exerted large pressure on the
Pusher.
1. Juicing Sieve was not
installed in even position;
2. The Juicier was not placed
smoothly and steadily or its foot
pad came off;
3. Voltage is overhigh;
4. Ingredients are excessive.
Cutter was twined by ingredients
or deadly locked.
Motor gives out disguis-
ing smell during the first
few times of use
Stop during operation
Fruit contains much
pomace
Few fruit comes out
Abnormal vibration or loud
noise
Obstructed cutter
Normal phenomenon
1. Put the Center Ring in place;
2. Put the Top Cap in place;
3. Replace Top Cap;
4. Put all parts in place.
1. Check if the voltage is too low;
2. Disconnect power source and
take redundant ingredients out;
3. Lightly press the Pusher;
4. Switch it off for 20-30 minutes
before use it again.
If the smell remains after using for
several times, please send it to
specified maintenance station.
1. Put the Juicing Sieve in place;
2. Put the Juicer smoothly and
steadily or put the foot pad in
place;
3. Check if the voltage is overhigh;
4. Disconnect the power and take
excessive ingredients out.
1. Replace the broken Juicing
Sieve;
2. Replace the Center Ring.
1. Clean the Center Ring;
2. Lightly press the Pusher.
Disconnect the power, take
ingredients out and cut it into
smaller pieces.
. 7 .
