TecSup 80300106 J, Руководство пользователя

Страница: 21 / 44

BABY
TECSUP – BABY – Users manual - 80300106 J – P 20 / 41
4.2 As a lamp with “back-up power”, plugged into mains
power
BABY is plugged into the mains power and switched “On”, (E=100%,
50%, 15%, “Beacon”, “SOS”, depending on users choice).
- If the mains power disappears, BABY passes automatically to
“Back-up” mode on the battery pack and the autonomy will depend
on the remaining battery charge level.
- If the mains power returns, BABY turns back to mains power supply
without altering the power of light, 100%, 50%, 15%, “Beacon”,
“SOS”, chosen by the user; simultaneously, the battery will begin to
recharge itself. The charging time depends on the temperature inside
the BABY.
>>> Typical cases of use: emergency lighting unit, evacuation light,
critical interventions, etc.
4.3 In mode “stand-by”, plugged into mains power
The «stand-by» mode is obtained by holding down the “Lighting”
button for more than 3 seconds. The lamp must be switched on during
this action.
The blue flashing led confirms the operation.
BABY is plugged into the mains power on the “Off” position. When
mains power is present, the light remains off, the charger maintains the
battery charge level at its maximum.
- If mains power disappears, the lamp will light up automatically,
powered by the battery pack.
- The moment the mains power returns, BABY switches off, recharging
the battery while remaining in “Stand-By” mode.
At the same time, the battery completes its recharge.
When the first power-cut occurs, the autonomy of the light has been
voluntarily limited to 2hrs30, the light will then switch off, this is to
preserve battery power by keeping reserve power. Thus, if mains power
disappears again (after 30sec minimum), BABY will light up and will
continue to function for 2 hours.
>>> Typical uses : events/shows, emergency evacuation, Back-up
lighting, etc.