Router Inalámbrico AW4062 4-port ADSL2+ Router User‘s Manual
Page 10 of 81
Label
Color
Function
Red / Green
Steadily off: Power is off.
Red solid on: Power on self test (POST) or fail to boot up.
Green blinking: while booting.
Green steadily on: Boot process is successful.
ETHERNET
1-4
Y-Green
Steadily off: Wired interface not established (Ethernet cable not detected
or not connected properly).
Blinking: Traffic is passing thru.
Steadily on: Wired interface established (Ethernet cable detected).
WLAN
Y-Green
Steadily off: Wi-Fi is disabled.
Blinking: Traffic is passing thru.
Steadily on: Wi-Fi is activated.
WPS
Green
Yellow
Red
Blinking yellow: activation of WPS process (association started, in
progress)
Solid green: connected successfully; session established then off after
10 seconds.
Blinking red: failure (whatever it is during the process)
CONEXIÓN
Y-Green
Steadily off: No ADSL connected.
Blink slowly: DSL attempting sync when trying to detect carrier signal.
(2Hz with 50% duty)
Blinking fast: DSL attempting sync when the carrier has been detected
and the modem is trying to train. (4Hz with 50% duty)
Steadily On: DSL good sync. Link established.
INTERNET
Y-Green
Steadily off: ADSL connection is not present or modem is configured in
bridge mode.
Blink: IP connected and IP Traffic is passing thru the device (both ways).
Steadily on: PPP connection established or Static WAN IP assigned
successfully.
Red: Device attempted to become IP connected and failed (no DHCP
response, no PPPoE response, PPPoE authentication failed, etc).
