TECO TPO29CFAT, Руководство пользователя, Страница: 5 / 24

Installation Instructions
EXHAUSTING HOT AIR
In the Cool Mode the appliance must be placed close
to a window or opening so that the warm exhaust
air can be ducked outside.
First position unit on a flat floor and make sure there's
a minimum of 17.7" (45cm) clearance around the unit,
and is within the vicinity of a single circuit outlet
power source.
1. Extend either side of the hose (Fig.1)
2. Screw the hose inlet (Fig.2).
3. Screw it to the hose inlet (Fig.3).
4. Install the hose inlet into the unit (Fig.4).
5. Affix the hose outlet into the window slider kit and seal. (Fig.5 &6).
The window slider kit has been designed to fit most standard vertical and horizontal
window applications. however, it may be necessary for you to modify some aspects
of the installation procedures for certain types of windows. The window slider kit can
be fastened with screws.
Note: If the window opening is less than the minimum length of the window slider kit, cut
the end without the hold in it short enough to fit in the window opening. Never cut out the
hole in window slider kit.
Installation Instructions
3