TECO 58A, Инструкция по эксплуатации

Страница: 29 / 44

ENGLISH • Instructions manual
29
TECO 58A
®
Automotive Equipment
WARNING!
Dispose of the used oil following current regulations.
5) Pheck the horizontal arm periodically.
N.B.: There may be some mechanical play at the tool-holder arm, or while
moving it, during the assembly and disassembly operations.
For longer component working life, it is advisable to
ADJUST THE SLIDE
SHOES
as described below:
a)
Disconnect the machine from the mains.
b)
Lift the tool-holder arm to the outside working position.
c) Loosen the guard fixing screws ( 1, Fig. J/4 ), remove the chain guard (
2,
Fig. J/4
).
d)
Loosen the nuts (
3, Fig. J/4
) for each upper slide shoe of the carriage
(
4, Fig. J/4
).
e)
Loosen the four register locking nuts (
1, Fig. J/5
).
f)
Screw each of the six slide shoe register screws (
2, Fig. J/5
) a quarter turn.
g)
Tighten the four locking nuts of the upper slide shoes (
3, Fig. J/4
).
h)
Tighten the four register locking nuts (
1, Fig. J/5
)
i) Refit the guard on the chain ( 2, Fig. J/4
).
N.B.: If the adjustment is insufficient, and there is still play, adjust the screws further, repeating the procedure described above
until all mechanical play has been eliminated.
J/4
1
2
3
4
J/5
1
2
15. MOVING THE MACHINE
The tyre changer has got a fork (
1, Fig. AZ ) which has been positionned there on purpose for moving the machine.
Follow these instructions:
1)
Low the turntable holding arm (
2, Fig. AZ
) completely down.
2)
Close completely the jaws of the chuck (
3, Fig. AZ
).
3)
Bring the carriage (
4, Fig. AZ ) at the end of its travel, near the arm.
4)
Insert into the lifting fork a hoisting belt (at least 60 mm wide and of
a lenght sufficient to bring the hook of the belt above the tyre changer).
5)
With the special belt ring bring the 2 ends of the belt together and
lift with a sufficiently strong lifting truck.
AZ
1
2
3
4