Tecnogasthai TCH60, Инструкция по установке и эксплуатации

Страница: 6 / 9

6
Re
g
u
la
rly
Use a soft cloth moistened with hand-warm mildly soapy
water or household cleaning detergent. Never use metal
pads, chemical, abrasive material or stiff brush to clean
the appliance.
Mo
n
th
ly
Metallic anti-grease filter:
The filter collects grease,
smoke and dust so the filter is directly affecting the
efficiency of the cooker hood. If not cleaned, the grease
residue (potential flammable) will saturate on the filter.
Clean it with household cleaning detergent.
Important: Clean the filter every month to
prevent risk of fire.
• Slide the upper chimney (2) into the lower chimney
(2). then pull the upper chimney upwards (fig 6) . Adjust
the height of the chimney to approximatly the required
height. Fix the upper chimney (2) on the bracket (3),
and secure on both sides with the 2 short screws (8) (fig.
7).
• Check tight fit of all parts. Bridging larger distances
• Bridging larger distances to the outdoors can be
achieved by installing an external motor inside the
exhaust duct. To do this, consult an electrician.
Bridging larger distances
• Bridging larger distances to the outdoors can be
achieved by installing an external motor inside the
exhaust duct. To do this, consult an electrician.
Installation without exhaust duct
• If you do not have an outlet to the outside, the exhaust pipe
is not required and the installation is similar to the one shown in
the Installation with exhaust duct section.
6. OPERATION
• Switch on the appliance at the switched fused connection unit.
The appliance is ready for operation.
Functions
Five-button panel
Extractor fan operating control pilot light.
Lighting on and off.
Extractor fan off.
Extractor fan speed - button: speed 1
Extractor fan speed - button: speed 2
Extractor fan speed - button: speed 3
To obtain the best results from your cooker hood it is
recommended that you leave it switched on for 15 minutes
after you have finished cooking.
7. MAINTENANCE
• Before cleaning, switch the appliance off and disconnect
the cooker hood from power supply.
• Clean the appliance in the following intervals:
Light bulb replacement
The lighting system fitted to the hood is just a
supportive light. In any case, it can not
substitute for the main lighting in the kitchen.
• Switch the appliance off and disconnect the power
supply.
• In order to replace light bulbs, both metallic anti-
grease filters should be detached first.
• Press the locks and pull the filters downward.
• Screw the light bulb from the holder and replace by
new light bulb of the same type, max. 50W (GU-10).
• Replace the metallic anti-grease filters and make
sure they lock in place.
6
7