4
• When assessing the measures necessary, always take the
entire ventilation system of the house into consideration. In
case of doubt, ask your local chimney sweeper for help.
• Never secure the cooker hood to a ventilation duct, or
a room or exhaust gas chimney! Do not let the air that
is removed from the room be drawn into a duct where
warm air is circulating. The extracted air should only be
drawn outdoors through a separate ventilating duct that is
only for the extractor hood.
• When in extraction mode, air in the room is being removed
by the cooker hood. Please make sure that proper ventilation
measures are being observed. The cooker hood removes
odours from room but not steam.
• There shall be adequate ventilation of the room when the
range hood is used at the same time as appliances burning
gas or other fuels (not applicable to appliances that
only discharge the air back into the room).
• The air must not be discharged into a flue that is used for
removing fumes from appliances burning gas or other fuels
(not applicable to appliances that only discharge the air back
into the room).
Cleaning
• There is a fire risk if cleaning is not carried out in accordance
with the instructions.
• Pay attention to the sharp edges inside the cooker hood,
especially during cleaning.
• Always disc onnec t t he power supply prior to c leaning
the cooker hood. If the switched fused connection unit is
difficult to reach, shut off the power supply by using the
corresponding circuit breaker at the distribution board.
• Keep the cooker hood clean. Fat deposits could catch on fire
when exposed to high temperatures.
3. INTENDED USE
• Your c o o ke r h o o d c an b e o p e r ate d in re c irc ulate d -
air operation or in exhaust operation.
• Recirculated - air: Kitchen fumes are removed and af ter
purification are fed back into the room through the upper air
outlet openings. The purification takes place via the grease
filters.
4. PARTS SUPPLIED
5. INSTALLATION
Important!
We recommend that two people carry out the
installation. Pay attention to the procedure described in the
assembly instructions.
Preparation
•
Exhaust operation:
The wall breakthrough (core
drill hole, min. 155mm) must be carried out by a
professional prior to installing the extractor hood.
Pay attention to the length of the exhaust hose when planning
the wall breakthrough. The exhaust hose must reach the
outer edge of the wall without any kinks.
Important!
If the exhaust hose leads through an outer wall,
the air outlet on the outside must be equipped with a cover
that has self-opening slits (not supplied). This can be installed
by the company that performs the wall breakthrough.
If open fireplaces are operated in the same room, ask your
local chimney sweeper about the local regulations prior to
installation.
If you are renting, then approval must be obtained from the
owner of the property.
•
Attention!
In order for the cooker hood to reach
optimal performance, mount it over the middle of the cooking
area.
• Plan the power connection prior to installation so that
a disturbing cable will not be visible afterwards.
• The following accessories are required to mount the
cooker hood (not included with the delivery):
→
Exhaust duct
→
Power drill
→
Screwdriver
→
Water level
→
Cable detector
No.
Part
Qty.
1 Cooker Hood
1
2 Upper and lower Chimney Sections
1+1
3 Brackets
2
4 Bulb
2
5 Aluminium Filter
600mm
x2
900mm
x3
6 Wall Screw (3,9mmx32mm)
6
7 Wall Plug Ø6
6
8 Short screw (3,9mmx13mm)
4
9 Collar
1
Содержание TCH60
Страница 2: ......
