TECNOEKA Srl ______________________________________________________________ use and instruction manual
page. 10 ________________________________________________________________________________________
30 ° C.
When the preheating temperature is reached, the message "P - H" flashes on the display and a
buzzer sounds.
At this point it is necessary to open the door of the oven, introduce the food to be cooked and
close the door: the acoustic signal is deactivated and the cooking cycle starts.
12. Displaying / changing parameters with the cooking cycle ON
When the cooking cycle is on, parameters can be displayed by pressing the
button and values
can be changed (keys
) in each step (
button) in the cooking cycle.
Several seconds after the last change (for any of the four steps) operating step parameters are
displayed (led blinks on current step).
If the
“Time” parameter is selected
The value set for the selected step (led on symbol
) is displayed for 4 seconds alternated by the
remaining total (COUNT DOWN) for the rest of the other steps for 4 seconds (led blinks on symbol
).
“Temperature” parameter
The value set for the selected step (led on symbol
) is displayed for 4 seconds alternated by the
value read in the cooking chamber for 4 seconds (led blinks on symbol
).
“Humidity” parameter
The set value is displayed for the selected step (fixed led on symbol
).
“Heart” temperature parameter (
for ovens predisposed)
The display will cycle for 4 seconds, the value set for the selected phase (LEDs mounted on symbol
) and for 4 seconds the measured value within the food
(LED flashing on symbol
)
N.B.:If you have not connected (in the socket) the thermal probe-shaped pin, instead of reading
the writing appears “_ _ _”.
13. Delayed start to the cooking cycle
To delay the start for the cooking cycle, proceed as follows:
Set the required parameters for each phase in the cooking cycle, following the instructions in
the paragraph “OPERATING METHOD” (paragraph 10).
Press the
key until all the signal leds go out on the control panel. The message “0.00”
appears on the display.
Press the
/
keys and set the required “DELAY TIME” on the display (maximum 9
hours and 59 minutes).
Press the
key to activate the delayed start.
The led on the
key starts flashing to show that the COUNTDOWN has started shown on the
display. The DELAY TIME can be changed at any moment during the COUNTDOWN by pressing
the
/
keys.
When the DELAY TIME is up, the cooking cycle will start automatically.