9
ENG
• Do not allow such substances to come into contact the appliance
parts.
• Do not use any abrasive cleaners
• Remove the food from the freezer. Store them in a cool place, well
covered.
• Switch the appliance off and remove the plug from the socket, or
switch off the circuit breaker or fuse.
• Clean the appliance and the interior accessories with a cloth and
lukewarm water. After cleaning wipe with fresh water and rub dry.
• After everything is dry place appliance back into service.
Defrosting of the freezer
The freezer compartment, however, will become progressively
covered with frost. This should be removed. Never use sharp metal
tools to scrape off frost from the evaporator as you could damage
it. However, when the ice becomes very thick on the inner liner,
complete defrosting should be carried out as follows:
• pull out the plug from the socket;
• remove all stored food, wrap it in several layers of newspaper and
put it in a cool place;
• keep the door open, and placing a basin underneath of the
appliance to collect the defrost water;
• when defrosting is completed, dry the interior thoroughly
• replace the plug in the power socket to run the appliance again.
Replace the lamp
CAUTION!
The product is equipped with LED light, please contact after sales
service in case of replacement.
CAUTION!
Before troubleshooting, disconnect the power supply. Only a qualified electrician of competent person must do the troubleshooting that is not
in this manual.
IMPORTANT!
There are some sounds during normal use (compressor, refrigerant circulation).
If the malfunction shows again, contact the Service Center.
TROUBLESHOOTING
Problem
Possible cause
Solution
Appliance does not
work
Temperature regulation knob is set at number “0”. Set the knob at other number to switch on the appliance.
Power plug is not plugged in or is loose
Insert power plug.
Fuse has blown or is defective
Check fuse, replace if necessary.
Socket is defective
Socket malfunctions are to be corrected by an electrician.
The food is too warm.
Temperature is not properly adjusted.
Please look in the initial Temperature
Setting section.
Door was open for an extended period.
Open the door only as long as necessary.
A large quantity of warm food was placed in the
appliance within the last 24 hours.
Turn the temperature regulation to a colder setting
temporarily.
The appliance is near a heat source.
Please look in the installation location section.
Appliance cools too
much
Temperature is set too cold.
Turn the temperature regulation knob to a warmer setting
temporarily.
Unusual noises
Appliance is not level.
Re-adjust the feet.
The appliance is touching the wall or other
objects.
Move the appliance slightly.
A component, e.g. a pipe, on the rear of the
appliance is touching another part of the
appliance or the wall.
If necessary, carefully bend the component out of the way.
Water on the floor
Water drain hole is blocked.
See the Cleaning section.
Side panel is hot
Condenser is inside the panel.
It’s normal.
