TECHWOOD TCA-170EX, Инструкция по эксплуатации

Страница: 10 / 14

10
To get a cup of cappuccino, cover the surface of the coffee with milk froth.
1. First prepare the espresso with a cup large enough to support the addition of
milk froth.
2. Press the "steam control" button and the indicator light flashes red. Wait for the
light to come on continuously, preheating is completed.
3. Fill 1/3 cup of whole milk.
4. Insert the steam nozzle 1 to 2 cm into the milk.
Note : always release some pressure before frothing milk.
5. Slowly turn the steam knob counter-clockwise (to the left) until the steam starts
to come out. Move the container slightly up and down, turning.
Notes : It is recommended to use whole milk cooled to the temperature of
fridge. (Never use hot milk !).
In choosing the pot size, it is recommended to use a diameter container
greater than 70 mm, and to keep in mind that double milk of volume by
becoming a froth of milk.
Make sure the height of the pot is big enough.
Never turn the steam control knob quickly because the water vapour can
come out quickly and increase the risk of splashes.
6. When the milk froth is formed, turn the steam control knob to "0" clockwise (to
the right).
7. Press the "steam control" button again. The indicator light turns blue.
Note : It is also possible to press the on / off button to turn off the machine.
8. Gently pour the emulsified milk onto the already prepared espresso.
• Sweeten if necessary.
• Sprinkle some cocoa powder on the frothed milk.
- The cappuccino is ready.
9. Set the selector to the "0" position to stop the steam and push on the on / off
switch to stop the espresso machine.
Notes : Clean the tube of the steam nozzle, with a damp sponge, immediately
after use because the milk sticks on the tube.
Finally, spray with steam to prevent the hole inside the nozzle is clogged
after drying milk.
Be careful not to get hurt because the tube stays very hot for a long time.
We recommend letting the machine cool down, for at least 5 minutes,
before making an espresso again. Otherwise a smell of burned can occur
in your espresso.
PRODUCE STEAM TO HEAT LIQUIDS
The steam nozzle (without the foaming device) can be used to make hot drinks
such as hot chocolate, water or tea.
Method
1. Open the tank lid,
2. Fill with the desired amount of water.