PRECAUTIONS
4
Read This Before Operating
Choose the installation location of your unit carefully.
Avoid placing it in direct sunlight or close to a source of
heat. Also avoid locations subject to vibrations and
excessive dust, heat, cold or moisture.
The ventilation holes should not be covered. Make sure
there is at least 20 cm (8 inches) of space above and at
least
5
cm
(2
inches)
of
space
beside
the
amplifier/receiver. Do not place a CD player or other
equipment on top of the amplifier/receiver.
Do not open the cabinet as this might result in
damage to the circuitry or electrical shock. If a foreign
object should get into the set, contact your dealer.
When removing the power plug from the wall outlet,
always pull directly on the plug, never yank the cord.
Do not attempt to
clean
the
unit
with
chemical
solvents as this might damage
the finish.
Use
a
clean, dry cloth.
Keep this manual in a safe place for future refernce.
TO THE USER
This equipment has been
tested
and
found
to
comply with the limits for a A/V receiver, pursuant to
Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against interference
in
a residential area. This device generates and uses
radio frequency energy and if not installed and used in
accordance with the instructions, it may cause interfer-
ence to radio or TV reception. If this unit does cause
interference with TV or radio reception you can try to
correct the interference by
one
or
more
of
the
following measures :
a) Reorient or relocate the receiving antenna.
b) Increase the separation between the equipment and
the receiver.
c) Plug the equipment into a different outlet so that it is
not on the same circuit as the receiver.
If necessary, consult the dealer or an experienced
radio/TV technician for additional suggestions.
CAUTION
Changes or modifications to this equipment not
expressly approved by WELTON U.S.A. for compliance
could
void
the
user’s
authority
to operate this
equipment.
For U.S.A
The equipment draws nominal non-operating power
from the AC outlet with its POWER switch in the
STANDBY position.
AC POWER CORD CONNECTION
CAUTION :
TO PREVENT ELECTRIC SHOCK, MATCH WIDE
BLADE OF PLUG TO WIDE SLOT, FULLY INSERT.
ATTENTION
Pour éviter les chocs électriques, Introduire la lame la
plus large de la fiche dans la borne correspondante de
la prise et pousser jusqu’au fond.
For CANADA AND U.S.A.
