22
16:9 WIDE
(Widescreen) — If you have a widescreen TV set,
use this setting. The DVD plays in full size. (You must also
set your widescreen TV to “full size”).
SELECTING DIGITAL AUDIO OUT
Each DVD has a variety of audio output options. If you
connected a Component to the receiver’s digital optical jacks
(see “Connecting a Digital (Optical) Audio Component” on
Page 7), you might have to change the digital audio output
setting. Set the player’s Digital Audio Output according to the
type of audio system you use.
1. Press
DVD SET UP
.
2. At the setup screen, press or to select
DIGITAL OUT
3. Repeatedly press
ENTER
to select the desired output (
PCM
or
BITSTREAM
) , then press
ENTER
.
BITSTREAM
— Select
BITSTREAM
if you have an amplifier
or other equipment with DTS decoder or Dolby Digital
decoder connected to the receiver.
PCM
— Select
PCM
if you have an amplifier or other
equipment with linear PCM only (or a MD recorder or a
DAT deck) connected to the receiver.
C
CC
Caaaauuuuttttiiiioooonnnn: : : : If an active digital audio output signal is supplied to a
receiver or other equipment without a corresponding digital
decoding capability, a very loud noise might be produced
which could permanently damage your speakers.
N
N
N
Nooootttteeee:::: When you make a digital recording from a CD to your
audio CD receiver, entire CD tracks are recorded as one track
because there is no track information.
