TechVision ID-S2LIR100W2, Руководство пользователя

Страница: 32 / 56

26
Network Camera User Manual
Set the alarm area number on the right side. Only one alarm area can be added.
Click “Draw Area” and then draw a rectangle in the image on the left side. Click “Stop Draw”
to stop drawing. Click “Clear” to delete the alarm area. Click “Save” to save the settings.
5. Set the schedule of the intrusion detection. The schedule setup steps of the intrusion
detection are the same as the schedule recording setup (See
Schedule Recording ).
Configuration requirements of camera and surrounding area
1. Auto-focusing function should not be enabled for intrusion detection.
2. Avoid the scenes with many trees or the scenes with various light changes (like many
flashing headlights). The ambient brightness of the scenes shouldn’t be too low.
3. Cameras should be mounted at a height of 2.8 meters or above.
4. Keep the mounting angle of the camera at about 45°.
5. The detected objects should not be less than 1% of the entire image and the largest sizes of
the detected objects should not be more than 1/8 of the entire image.
6. Make sure cameras can view objects for at least 2 seconds in the detected area for accurate
detection.
7. Adequate light and clear scenery are crucial to intrusion detection.
4.5 Network Configuration
4.5.1 TCP/IP
Go to Config  Network  TCP/IP interface as shown below. There are two ways for network
connection.