TechVision ID-S2LIR100W2, Руководство пользователя, Страница: 26 / 56

20
Network Camera User Manual
3. Set the schedule of the motion detection. The schedule setup steps of the motion detection
are the same as the schedule recording setup (See
Schedule Recording ).
4.3.2 Other Alarms

SD Card Full
1. Go to Config  Alarm  Anomaly  SD Card Full.
2. Click “Enable” and set the alarm holding time.
3. Set alarm trigger options. The setup steps are the same as motion detection. Please refer to
motion detection chapter for details.
 SD Card Error
1. When there are some errors in writing SD card, the corresponding alarms will be triggered.
2. Go to Config
 Alarm  Anomaly  SD Card Error as shown below.
3. Click “Enable” and set the alarm holding time.
4. Set alarm trigger options. Trigger Email and FTP. The setup steps are the same as motion
detection. Please refer to motion detection chapter for details.
4.3.3 Alarm Server
Go to Alarm  Alarm Server interface as shown below.
Set the server address, port, heartbeat and heartbeat interval. When an alarm occurs, the
camera will transfer the alarm event to the alarm server. If an alarm server is not needed, there