Techsis SE-4048, Руководство пользователя

Страница: 8 / 16

SE-4048
Tel
:021-22371482 ,
Fax
:021-66402031
Www.techs.is , Sales@techs.is
Page
8
Chapter 2 Hardware Connection
2.1 Connecting RJ45 port
Connect the switch and the RJ45 port of the peer network device with a network cable.
2.2 Connecting SFP Ports
The SFP port of the SE-4048 supports only 10 Gigabit fiber modules. It is recommended
to use standard SFP module products.
The process of installing a fiber module on a switch is as follows:
1. Grasp the fiber module from the side and insert it smoothly along the SFP port slot
of the switch until the fiber module is in close contact with the switch;
2. Confirm the Rx and Tx ports of the fiber module when connecting. Insert one end
of the fiber into the Rx and Tx ports to ensure that the Tx and Rx ends of the
interface are correctly connected, and the other end of the fiber is connected to
another device.
3. After power-on, check the status of the corresponding indicator. If the indicator is
on, the link is up. If the indicator is off, the link is down. Check the line and
confirm that the peer device is enabled.
Note:
It is not allowed to excessively bend the fiber, and its radius of curvature should be no less
than 10cm;
Ensure the cleanliness of the fiber end face;
Please do not look directly into the fiber optic connector with your eyes, as this may cause eye
damage.