Techsage Spinjet 6200, Руководство оператора

Страница: 14 / 22

- OPERATORS MANUAL
Page 14
4. Operation
Connect the SPINJET Control Box to a power outlet (see ‘Safety
precautions’ on page 1).
Switch the Control Box on with the rocker switch. A red light in
the button indicates the Control Box is ‘on’.
The normal, automatic SPINJET sequence upon power up is:
Initialize followed by Standby .
Switch the Printer on.
The normal, automatic SPINJET sequence during initialization of
Printer is:
Initialize followed by Ready.
If SPINJET does not enter Ready mode during initialization of
Printer please refer to
Section 4.1 Printer Set Up .
Please Note: Always turn on the SPINJET before the Printer.
4.1 Printer Set Up
Check that the Printer is set according to the requirements of the
installation procedure. In particular, the following should be
observed:
Set up the Printer as follows:
PRINTER SETUP / ACCESSORIES / DUPLEXER / YES
The SPINJET will perform following automatic SPINJET sequence
when setting DUPLEXER from NO to YES:
Initialize followed by Ready.
Please note:
 Unload Roll media from Printer before setting DUPLEXER to YES.
 Setting DUPLEXER to NO will disable all communication between
the Printer and the SPINJET and double sided printing is disabled.
4.2 Color calibration on the Printer
The Printer Color Calibration will not work when Duplexer is installed.
In order to calibrate color you must select “ Uninstall Duplexer” in
the “ Paper menu / Accessories / Duplexer ” menu
When duplexer is uninstalled go to Setup Menu / Configuration /
Color Calibration /
Select “ Calibrate Now”
When calibration is finished; unload media
Go to
Paper menu / Accessories / Duplexer select “ Install
Duplexer ”
Reload media roll.
4.3
Operation Modes
The SPINJET has 7 operation modes indicated by the LED’s on the
Keypad.