TSR 2800-20-DC Router’s Hardware Installation Manual
- 19 -
C. When uninstalling the two locating steel slices, break off them outwards. At the
same time, push down the SDRAM extensible bar until the circuit board completely
breaks away the locating steel slices. Plug out the SDRAM extensible bar in an angle
of 45 degree.
After the SDRAM bar is installed, install the hull according to the procedure of closing
the hull.
4.3 Closing Chassis
The section mainly describes how to put the cover and close the chassis. Do as
follows:
z
Put them well according to their locations and joint them together along their
sides.
z
See the following figure.
z
When the cover and the bottom are closely tied, let the cover slide the slot of the
front template at the bottom.
z
Nail the bolt and screw it tightly with the screwdriver.
z
Reinstall the router on the cabinet or the desk.
z
Reconnect all cables of the switch.
