16E1+4ETH Optical Multiplexer
13
5 Installation
5.1 Equipment installation
After unpacking and before installation, make sure checking the following:
Make sure the package is well. If the package is damaged, contact
service office quickly for solution.
Check the package according to the product list, if find equipment severe
damaged or
lack
of some components, please contact installation worker or
service office of us.
Check whether the equipment type meets with the type you ordered.
Check whether the component is in integrity.
Check the power supply type.
5.1.1 Quick installation
Fasten the Equipment in 19 inch rack with the screws in the equipment
package.
Use reliable ground connection at GND point of the equipment
Use power tab to connect power according to the manual, don’t
exchange the polarities.
Create user equipment connecting wire according to your demand (2M,
V.35 and 10 Base-T), then connected, don’t exchange receive and
transfer wires.
Connect receive and transfer optical with optical receive and transfer
port of the equipment. Don’t exchange receiving and transmitting wire,
make sure the optical fiber head is clean, insert optical jumper, make
sure connection well. (fiber bending radius≥50 mm)
Use multimeter to test power polarity and voltage, make sure it
matches with equipment requirement.
After complete installation and make sure it’s ok, power on the switch.
Check indicator light meet with practice situation (see related part of
