Specifications
Fuselage
length
:
884mm
(
34
.
8in
)
Wingspan
:
845mm
(
33
.
2in
)
Flying
Weight
:
135
-
160g
(
with
battery
)
Instruction
Manual
Malibu2
F3P
Malibu2
F3P
Before
use
,
please
read
the
explanations
carefully
!
l
Laser-cut 3mm genuine EPS parts for optimum strength and
Minimum weight .
l
Lightweight carbon fiber truss system virtually eliminates flex .
l
Ideal for indoor flight and capable of outdoor flight in low winds.
l
Minimal assembly required flight ready in as little as 3 hours .
l
Vibrant screen printed trim scheme.
Warning
An R/C aircraft is not a toy! If misused, it can cause seriousbodily harm and
damage to property. Fly only in open areas,preferably AMA (Academy of
Model Aeronautics) approvedflying sites, following all instructions included
with your radio.Always assume the electric motor can come on at any time
souse extreme caution.Before beginning assembly of your
, we
strongly uggest that you read through this instruction manual so you
canbecome familiar with the parts and the assembly sequence.Assemble the
kit according to the sequence provided in the instruction manual. Do not
attempt to modify or change the kit design as doing so could adversely
change the models flying characteristics.
Malibu2-F3P
s
Additional Required Equipment
Motor: 2403
KV
:
2100
ESC: 10 A
GWS 804
Radio 4 more channel
Receiver 4 more channel
Battery charger
7.4V
mAh
Propeller
:
0 Slow Flyer Prop
Servo
:
5G
*
3
: /
: /
Battery
:
350
-
500
(
25C
)
Introduction
Thank you for purchasing the Malibu2-F3P.
The Malibu2-F3P ARF has superb slow flight responsiveness so you can fly
high-alpha 3D with authority. Its carbon fiber reinforced Malibu2-F3P
construction provides the solid, precise feel of a balsa profile plane without the
weight. This allows you to fly the Malibu2-F3P ARF outside in windier conditions
that would keep most other profile foamies grounded. The Malibu2-F3P ARF is
another exciting addition to TECHONE's outstanding line of electric RC aircraft
and accessories.
TECHONE uses top-quality engineering and materials in everything it makes, so
you always get the maximum level of value and fun. TECHONE backs all of its
products with the best customer service and support in the hobby so your electric
flight experience is always a positive one.
These assembly instructions are designed to guide you through the entire
assembly process of your new airplane in the least amount of time possible. Along
the way you'll learn how to properly assemble your new airplane and also learn
tips that will help you in the future. We have listed some of our recommendations
below. Please read through them before beginning assembly.
Required Tools and Adhesives (not included in the kit)
5 Minute Epoxy
Glue
Aerosol Zip-Kicker
# 0 and #1 Phillips Head Screwdrivers
1.5mm Hex Wrench
Adjustable Wrench
Wire Cutters
Z-Bend Pliers
Needle Nose Pliers
Modeling Knife
Scissors
Electric or Hand Drill
Assorted Drill Bits
Straight Edge Ruler
Pencil
T-Pins
Builder's Triangle
220 Grit Sandpaper with Sanding Block
Masking Tape
Paper Towels
Rubbing Alcohol
Epoxy Mixing Sticks
Epoxy Mixing Cups
Soldering Iron
