-
3
-
Cut 45
bevel on the four ailerons.
Use 3M magic tape to splice the four ailerons and the upper and
lower wings.
Glue the aileron horns onto the upper and lower
ailerons with some foam-friendly C/A.
Attach the included z-bends to the suitable length of carbon
fiber pushrod using heat shrink tube. Use a soldering iron
or heat gun to shrink the pushrod to the z-bend.
Install the motor mount.
Cut a 45
bevel as shown.
Cut a 45
bevel as shown.
Glue the fuselage stringers onto the sides of the fuselage.
Cut the both ends of the foam strips as 45
bevel.
Glue suitable length of carbon fiber strip to the
front of the foam strip as show, then attach the
foam strips to the upper wing and fuselage and
fix them with foam-friendly C/A.
170mm
