Installation and Operating Instructions - TT-KS Mobile Application
Feel good through warmth from electricity - www.technotherm.de
GB
2. Use with an internal temperature controller (built-in on the lateral side of the device)
As soon as the heater is completely assembled and installed by an authorized elec-
trician, you can start using it.
Please turn the control knob to the desired room temperature (for example, temperature 21°C
during the day). Now the electrical surface storage heater is switched on and heats automat-
ically. When the set temperature is reached, the power supply will be interrupted. However,
the heater will still radiate heat stored in the ceramic storage core. As soon as the room tem-
perature drops, the room thermostat switches ON the heater again. This process is repeated
continuously, as long as the heater is at the operation mode. If you are going to be absent for
a longer period of time, please set the temperature to a lower level to save energy. If you turn
the control knob completely to the left, the heater will be switched OFF.
2.2 Installation with internal temperature controller (built-in to the side of the unit)
The desired room temperature is regulated by a built-in thermostat.
To do this, set the control knob to the right position as shown by the red light:
Position 1 : about 5°C (frost protection)
Position 4 : about 20°C
Position 6 : about 30°C
A light indicator shows
the warming-up status of the heat-
er.
The temperature sensor belonging
to the device is installed at the bot-
tom of its lateral side. Its settings
are to be made by your plumber.