www.technotherm.com
Installa� on and Opera� ng Instruc� ons
Panel Heater MCT
www.technotherm.com
GB
14. Temperature calibra� on
In some cases it can happen that a radiator measures a room Temperature that is not representa� -
ve for the room in which it is mounted. This can have several causes. For instance, when the sensor
measures just in a draught. Some� mes residents also have other measuring devices where they want
to see the same Temperatures. In that case one can adjust the Temperature sensor.
If, for example, the radiator switches off 1° too early (so the room remains too cold), the parameter
should be set to -1 in these se� ngs.
If, for example, the radiator switches off 1° too late (i.e. the room becomes too warm), the parameter
should be set to +1 in these se� ngs.
Changing the Temperature calibra� on is done by following the steps below:
•
Make sure that the device is switched off . This can be done by pressing the rightmost ("Off ") but-
ton. If only the � me is shown, or --:--, then the radiator is switched off .
1.
Now press the „MODE“ bu� on for 5 seconds.
2.
Now briefl y press the „Mode“ bu� on twice.
3.
You can adjust the value with the „plus“ and „minus“ bu� on.
Standard it is set on „0“ off set.
4. When you have changed the value, confi rm with the „Mode“ or „STOP“ bu� on.
15.Reset to factory se� ngs
This func� on resets all se� ngs made, and returns the unit to the factory se� ngs.
Please note that all self-set hea� ng programs will also be deleted.
•
Make sure that the unit is switched off . You can do this by pressing the rightmost („Off “) bu� on. If
only the � me is displayed, or --:--, then the radiator is off .
1.
Press the „Mode“ and „STOP“ bu� on simultaneously, and hold for at least 10 seconds.
The following screen will appear:
2.
Then press these bu� ons again simultaneously and hold for at least 5 seconds. The following
screen appears:
