Technotape 3DT.SUB.OVN.001, Руководство пользователя

Страница: 12 / 18

Pre-heating Settings
Press the pre-heating button for adjusting pre-heating time for the foil (see image 3.2.7). Adjust time by pressing the button marked
with arrows in the middle of the control panel, up (see image 3.2.8) or down (3.2.9). After setting the pre-heating time press the
home button to confirm.
Image 3.2.8 Image 3.2.7 Image 3.2.9
3.3 Recommended Settings
The followings standards are recommended for the Technotape
3D Sublimation Phone Cases
NOTE:
these standards apply for usage stated under Quality
Guarantee and Service (see 3.1).
Temperature: 150°C
Vacuum time: 5:30 minutes
Pre-heating time: 6 seconds
3.4 Placing the Jigs
Install the jig pin in the baseplate, fasten by hand and place the
production jig(s) accordingly.
NOTE:
After exchanging a production jig make sure it is
thoroughly preheated
WORKING WITH THE 3D SUBLIMATION OVEN
12