Istr-3 Lingue-CP1E.doc Pag. 5 di 6
INSTRUCTION TO USE FOR ELECTRONIC PISTOL SAFE
CP/1E”
In order to be able to open the door quickly even in the dark, the keys are not numbered.
The code is based on the sequence of pressing minimum 3 to 6 keys maximum.
The same key can also be repeated several times.
Fig. 1
The pistol safe is supplied with the factory code by pressing the keys
"1 2 3 4"
in sequence (see Fig.1)
Read carefully the instructions before using the pistol safe.
Keep your personal code in a safe place.
This safe is equipped with a key lock for opening the door in an emergency case. 2 keys are included.
Keep the keys of emergency lock in a safe place, but never inside the safety box.
It is recommended to replace the internal batteries every year (use only 1.5V AA alkaline batteries).
If the safety box is not used for a long period, it is recommended to remove the internal batteries.
Before installation, check the good functioning of the safe.
1. INITIAL SETTINGS
The safe is provided with the door closed.
Proceed to open the door using the emergency key.
Insert the key with the shaped part upwards (see Fig. 2), push it and turn it clockwise.
Attention:
the door will open automatically, therefore, you must pay particular attention and keep your face away
from the door's range of action, in order to avoid suffering contact with it during opening.
Remove the battery box cover (see Fig. 3) by pushing it upwards. and take it off. Remove the battery holder and
insert the 4 1.5V AA batteries, respecting the correct polarity (the spring must be on the – side of the battery).
Replace the battery holder inside the compartment, making sure that it is inserted correctly. Replace the battery
box cover.
2. OPENING / CLOSING WITH FACTORY CODE "1 2 3 4"
Close the door.
Press all 4 keys in sequence from right to left (as shown in Fig. 1).
The door will open automatically.
3. PERSONAL CODE PROGRAMMING: (with door open)
The personal code can be composed of minimum 3 to 6 keys maximum.
The same button can be pressed several times.
Press and hold the programming button
“Learn”
(see Fig. 4) until the keyboard led light changes from green to
red and beeps.
Within 13 seconds, enter your personal code consisting of minimum 3 to 6 keys maximum, even if one or more of
them is repeated.
Press and hold again the programming button
“Learn”
until the keyboard led light changes from green to red and
a beep is emitted.
Enter your code again by repeating the same key sequence previously carried out.
Press and hold again the programming button “Learn”, if the led light remains green and two beeps are emitted,
your personal code has been correctly memorized.
If the second confirmation sequence has not been correctly repeated, the red led will light up. In this case it will be
necessary to repeat the programming operation from the beginning.
