Technoplus multiflex 80280, Руководство по эксплуатации

Страница: 24 / 48

WORKING WITH THE MACHINE
24 Version 1.0
9. Working with the machine
9.1. Clamping the drill bit into the quick-change chuck
Important!
In order that all drill bits reach the same depth, it is necessary that all drill bits
are set to the same gauge "x".
1. Release the fastening screw "2" with the 4 mm hexagon key "1"
2. Insert a drill bit "4" into the chuck "5" up to the stop pin, observe the position of the
area "3"
3. Tighten the fastening screw "2"
9.2. Mounting the quick-change chuck on the boring head
1. Pick up a quick-change chuck with drill bit in one hand
2. Guide the quick-change chuck with drill bit up to a free head spindle
3. Slide the clamp collar with the other hand in the direction of the drill bit,
4. position the quick-change chuck with drill bit onto the spindle
5. Release the clamp collar and turn the quick-change chuck by approx. a 1/2 turn,
until the clamp collar returns to the initial position
6. When dismantling a quick-change chuck with drill bit, pull the clamp collar in the
direction of the drill bit and pull the quick-change chuck with drill bit away from the
spindle.