Technomate TM-Twin-OE, Руководство пользователя

Страница: 20 / 55

20
5.5. Step-5 Satellite Selection
Specifies the satellite(s) to receive signals from your dish antenna(s).
● Select the satellite(s) that you have installed for
tuner 1 and 2 correctly. Selected state will be
changed whenever you click OK key on the remote
control.
5.6. Step-6 Antenna Setup
You may need to change some parameters for your antenna and LNB to receive signals from the
satellite. You can find the signal with the signal meter display on the screen : it shows green blocks if the
signals found, or grayed if not found.
Please go to the next step if you found a few good signals.
For setup of a satellite, you can configure Antenna System, LNB Type, DiSEqC switches and Motor
Antenna if you have installed one.
● A1 “Astra 19.2E” shows the satellite selected
currently with the longitude and which tuner is
connected for the satellite.
● Antenna System : *DiSEqC, OneCable.
● LNB Type : *Universal, C-Band 1/2/3, Ku-Band
1/2/3, User Define.
● LNB Frequency : Specifies the frequency of LO
(local oscillator) in the LNB. You should select the
correct one installed.
● LNB Power : *Auto, Off, 13V, 18V - Supplies
electric power to the antenna system.
● LNB 22KHz : *Auto, Off, On
● 1st DiSEqC 1.0/1.1 : *None, 1/4 ~4/4, Tone A, Tone B, 1/16 ~16/16
● 2nd DiSEqC 1.0/1.1 : *None, 1/4 ~4/4, Tone A, Tone B, 1/16 ~16/16
● OneCable Status : Select the Red key to install.
● User Band : 1, 2, 3, 4
● UB Frequency : 1400, 1516, 1632, 1748 MHz
● MDU : *No, Yes - Select YES if you installed the Multiple Dwelling Unit system, “No” for Single