(
BRIGHTNESS
key
)
RESETTING
The Projection Clock and the transmitter need to be reset when one of the following conditions occur:
•
Unsuccessful 433MHz signal reception.
•
Malfunction on the units.
•
Batteries replacement.
•
Failure in detecting the air pressure during the setup operation (In this case, the weather icon,
“TENDENCY” icon, and both upward and downward arrows will be flashed.).
For resetting, remove all batteries from the units and unplug the AC-DC adapter from any power source. Wait at
least for
3 minutes
before powering up the Projection Clock again. Proceed from step 1 in
“Setting Up”
above.
FUNCTION KEYS
The Projection Clock uses the following keys:
SNOOZE
: Activate or deactivate snooze function.
: Show alarm time.
: Activate the projection at the highest brightness level.
: Exit the setting modes.
:
Back-light
On.
AL/HR
: Enter alarm setting mode.
: Activate or deactivate alarm.
: Stop alarm and snooze function.
: Set the hour and day.
:
Back-light-On.
MODE/MIN
:
Toggle between indoor temperature, second, weekday-day, and day-month display mode.
: Enter manual time setting mode and time zone setting mode.
: Stop alarm and snooze function.
: Set the minute, weekday, month and year.
:
Back-light On.
: Set the brightness level of the projection (in AC power mode only).
(4 levels: High, Medium, Low, OFF).
:
Back-light
On.
DISPL
: Toggle between the time and outdoor temperature or automatic alternates time/outdoor
temperature every 5 seconds display mode for projection.
:
Back-light
On.
: Project the image direction (can display 4 different orientations).
:
Back-light
On.
HOW TO USE THE PROJECTOR
(DIRECTION
key)
The projector projects the current time and the current outdoor temperature onto a wall or ceiling, preferable
within a darkened room
.
It can be adjusted forward and backward 180º for maximum projection range. Also,
the projection image can also be adjusted in 4 upright positions, each with a rotation of 90º.
To project the time or the outdoor temperature onto a flat surface:
1.
Point the projection lens to the appropriate direction (maximum distance of the projection is 2 meters).
2.
Press the DISPL key to select the desired mode for the projection. There are 3 display modes:
M 0 – projecting the current time only.
M 1 – projecting the current outdoor temperature only.
