Technoline RADIO CONTROLLED PROJECTOR CLOCK, Инструкция по эксплуатации

Страница: 9 / 10

6 9
battery door and insert 3 x AA batteries into the battery
compartment. Make sure you insert the batteries the
right way according to the polarity information marked
on the battery compartment.
2. Replace the battery door.
3. Press the “RESET” key to re-start the clock and it will
synchronize the channels of transmitter automatically.
NOTE:
1. The building material and the position of the receiver
and transmitter affect the effective range. So try various
locations to obtain the best result.
2. Place the units away from metal objects and electrical
appliances to minimize the interference. Position the
receiver and transmitter within the effective
transmission range: 80m
in usual circumstances.
RECEPTION OF RADIO CONTROLLED TIME SIGNAL
The time and date are radio-controlled. The current time
and date are automatically synchronized with the time
signal transmitted from Germany (DCF 77)/U.K. (MSF)/
USA(WWVB).
When used for the first time (after inserting the batteries or
pressing the “RESET” key), the clock will start to receive the
RC signal in 5 minutes with the signal strength indicator
flashing.
5. Press “TIME” key to save and exit the setting or let it exit
automatically 30 seconds later without pressing any key.
ALARM AND SNOOZE SETTING
1. In normal time mode, press “TIME” key to select the
ALM1 or ALM2.
2. In ALM1/ALM2 mode, press and hold “ALARM” key for
2 seconds until alarm Hour digit flashes.
3. Press “UP” or “DOWN” key to change the value.
4. Repeat the above operations to set time in this order:
Hour > Minute
5. Press “ALARM” key to save and exit the setting, or let it
exit automatically 30 seconds later without pressing
any key.
NOTE:
1. The alarm will be automatically turned on when you
set the alarm time with the icon “
” or “ ” displayed.
2. The dual-alarm (ALM1&ALM2) design of this unit will
provide you with more convenience, and you can set
two-alarm time if needed.
USING ALARM & TEMPERATURE PRE-ALARM FUNCTIONS
1. Set the alarm time as described in the previous section.
2. In normal time mode,press “ALARM ” key once to turn
on ALM1, press it twice to turn on ALM2, press it thrice