AutoGRAPH-GSM • USER MANUAL
25
TechnoKom © 2015
Connection of AutoGRAPH-GSM
controller
This section covers connection procedures of AutoGRAPH-GSM/GSM+ controllers:
• Installation of a SIM card
• Installation of an microSD card
• Connection of a GPS/
GLONASS
antenna
• Connection of a GSM antenna
• Power supply connection
• Digital inputs connection
• Analogue inputs connection
• Outputs connection
• 1-Wire connection
• RS-485 bus (TIA / EIA-485-A) connection
• RS-232 bus connection
• CAN bus (SAE J1939 / FMS) connection
To make the device ready for the simplest operation scheme it would be sufficient just to
install a SIM card, GPS/GLONASS and GSM antennas, and to connect a device to a power
supply source.
However, the hardware and software of AutoGRAPH-GSM controllers includes an extensive
range of features and capabilities, which allow for easy configuration, customization and
adaptation of the system to the needs of the user.
Application of digital and analogue inputs, outputs and data buses enables permanent
monitoring of various parameters (for example, fuel consumption and fuel level), as well as
to monitor operating conditions and performance of external equipment and devices and to
promptly respond to various events (for example, to the pushing of an alarm button). The
output of the controller enables the device to control various actuators and warning devices.
An external backup battery enables the controller to operate even when the main power fails.
All of these features allow the creation of diverse variants of the system able to perform
monitoring of a great number of parameters and to respond to various events.
The following sections focus on basic connection diagrams of various interfaces, inputs and
outputs of the AutoGRAPH-GSM controller.