Technogym Personal Selection TUV, Руководство по техническому обслуживанию

Страница: 26 / 70

Personal Selection TÜV: Service & Maintenance Manual - rev. 1.0
Page 5.2
5.2. THE WEIGHT STACK CABLE IS NOT TAUT
This problem is due to lengthening of the weight stack cable. Therefore, to solve the problem you
must use the cable tension adjustment system.
If the cable is new, before adjusting its tension, it is necessary to do a few reps at
maximum load to “stretch” the cable itself.
There are 2 possible mechanical solutions:
•
weight stack with crimped cable;
•
weight stack with doubling pulley.
the 2 different adjustment procedures detailed here below correspond to these two mechanical
options:
5.2.1. A
DJUSTING THE TENSION OF THE CABLE WITH CRIMPED FITTING
This operation applies to Abdominal Crunch, Leg Curl, Leg Extension, Lower Back.
Photo 5.2-1
1. Set the minimum weight: the only selected
weight will be the cross.
2. Loosen the counter-nut
a using a 22-gauge
wrench.
3. Tighten the screw b at the end of the cable so
that the cable is taut and the cross raised.
4. Slowly loosen the screw b until the cable is
still taut, but the cross is resting on the
weight stack.
5. Tighten the counter-nut a using a 22-gauge
wrench.
Check the tension of the cable by
carrying out a couple of repetitions with
the minimum weight, and then slowly
resting the cross on the weight stack.
The cross must rest firmly on the weight
stack, and the cable must be slightly
taut.
5.2.2. A
DJUSTING THE TENSION OF THE CABLE WITH DOUBLING PULLEY
This operation applies to Leg Press, Low Row, Rotary Torso, Upper Back and Vertical
Traction.