technoac AG-309.15G, Техническое описание, инструкция по эксплуатации

Страница: 58 / 67

58
DEVELOPMENT, MANUFACTURING AND SUPPLY OF INSTRUMENTATION
NOTE
While changing batteries, use only all 8 elements of “type C” produced by the
same company, from same series and condition (all 8 cells are always operable or
inoperable altogether). ALKALINE 1.5V batteries are recommended.
It is highly recommended to ensure that all 8 elements have approximately the
same charge level. The assessment can be done with the help of direct-current
voltage voltmeter, if all 8 elements are manufactured by the same company,
marked with the same series and of the same condition.
If the batteries kit has undergone a full “life-cycle” in the “energy consuming”
continuous mode “Co”, it is still likely to be used for quite a long time in economy”
pulse mode “Pu” at “low” output power (up to 2 hours at the initial power of 5 W).
11.6. Illustrative Use information about “Power Supply Monitoring”,
“Buttons Functionality” and “Symbols”
On..the..inner..side..of..the..cover,.there.is..information..on..
the..principles..of..the..following..information..types,.namely..
POWER..SUPPLY..MONITORING,..BUTTONS.FUNCTIONALITY..
AND..SYMBOLS..of..the..“Digital..field”.and.the.front.side.of.
the.panel.
11.7. “Multimeter” of the Output Parameters
In.the.“Digital.field”.during.oscillation.with.the.use.of.“clips”.or.“clamp”,.the.approximate.values..
of.the.output.parameters.are.indicated:
-.load.signal.voltage.in.volts.“ U,V ”
-.load.current.“ I,A ”..Minimum.measured.and.indicated.value.–.0.05A.“.05”,.current.is.indicated.
in.Amperes.(A).
Examples:
>than 0 and <50mA
I
< 50 mA
more 99mA
I
= 0,2 A
-.load.power.in.watts.“ P,W ”;
-.load.resistance.in.ohms.or.kilohms.“ R,(
Ω
/ k
Ω
) ”..In.“antenna”.modes.“In”.or.“An”.only.“U,V”.is.
indicated.(output.signal.voltage.applied.to.the.antenna)..The.accuracy.of.measurements.is.enough.
for. situation. assessment. at. load. resistance. up. to. 800
Ω
.. The. parameter. which. value. should. be.
indicated.in.the.“Digital.field”.is.set.by.the.“CHOICE”.button.“ ”.in.the.“Output.parameters.field”.
immediately.during.oscillation.process.
than 50mA and less than 99mA
I
= 60 mA