3-21
(11)
Verify that the FUSE BLOWN red LED is OFF.
(12)
Verify that the POWER ON green LED is ON.
(13)
Proceed to operate in the transmit mode, paragraph 3.5.3 or operate in the receive
mode, paragraph 3.5.4 as required.
3.5.2
Transmitter Operation
To operate the transceiver in the transmit mode, proceed as follows:
(1)
Set RF POWER switch (if applicable) to desired operating level.
(2)
Hold the microphone in one hand, with the upper edge of the microphone as close
as possible to the upper lip.
NOTE
This technique activates the noise cancelling feature
of the microphone. The microphone is most effective
when sound is ½ inch (12.7 mm) or more away from
the microphone.
(3)
Press and hold the PRESS-TO-TALK switch of the microphone during transmission.
(4)
Ensure that the Tx ON amber LED is ON.
(5)
Speak slowly and distinctly into the microphone using specified operating
procedures during transmission.
(6)
When message is ended, release the PRESS-TO-TALK switch of the microphone.
(7)
The transceiver is now operating in the receive mode.
(8)
Verify that the Tx ON amber LED is OFF.
(9)
Refer to previous paragraphs for Transceiver Operation and additional operating
modes.
Содержание TBS-150/8.33
Страница 15: ...2 3 Figure 2 1 Base Station Assembly Disassembly...
Страница 28: ...3 4 Figure 3 1 91 DE 8 33 Base Station Set Up...
Страница 31: ...3 7 Figure 3 2 Base Station Front and Rear Panel Layout...
Страница 42: ...3 18 Figure 3 3 Fixed Channel Jumper Locations...
