SECTION 2
I N S T A L L A T I O N I N S T R U C T I O N S
2.1
GENERAL
This section contains information and instructions for the correct installation of the TAC-
Dual Audio Controller.
Make certain that the unit is correctly operating in accordance with the equipment user’s
requirements prior to releasing the equipment for service.
2 . 2
EQUIPMENT PACKING LOG
Unpack the equipment and check for any damage that may have occured during transit.
Save the original shipping container for returns due to damage or warranty claims. Check
that each item on the packing slip has been shipped in the container. Verify that the
equipment’s backlighting configuration is the same as that required.
2 . 3
WIRING REQUIREMENTS
Airframe wiring should be MS22759 Tefzel or Raychem 44 (81044) single conductor and
shielded wire. Heatshrink solder sleeves (such as Raychem or equivalent) should be utilized
for shield termination.
All Microphone audio input line connections should be made with Shielded Cables. Audio
output lines may be twisted pairs. The power cables should be a minimum of #22 AWG.
Keying lines may be #24 AWG
DO NOT bundle low level audio lines with RF coaxial cables, motor, pump or blower wiring
which can cause coupling between the various systems, especially during RF transmission
or pump\blower mechanical operation. Maintain as much distance as possible from these
types of wire bundles.
2 . 4
AUDIO PANEL INSTALLATION
The TAC-200A Audio Panel is designed to be Dzus mounted and should be installed in
conjunction with installation kit P/No.
969732. See Figure
2-1 for and outline drawing of
the unit with dimensions to facilitate the installation.
All configurable and variable options of the TAC-200A can be set or changed simply and
without requiring the opening of the unit.
- A block diagram of the
50 pin “D”
connections is provided in
Table 2-l
- A block diagram of the
37 pin “D”
connections is provided in
Table 2-2
- A block diagram of the
15 pin “D”
connections is provided in
Table 2-3
2 - l
