27
Operation
Room sensor with UVR16x2, RSM610, CAN-I/O45, UVR1611 (>
A3.00 and serial number >13285) or with UVR63-H (> V7.2)
Pressing the
Key
causes the next value to be displayed. The basic display values are displayed in the
following sequence. Then the pre-programmed values become visible. If there are outputs that are
combined with a symbol, then the symbol is also displayed.
Rotation of the temperature selection knob in the direction of "
+
" the display value of the room tem
-
perature
at the controller is reduced
and vice-versa.
If during programming a value was entered in the menu "
TIME N
", the display automatically switches
at these intervals from one value to the next.
If a value was entered in the menu "
TIME B
", then after this time has elapsed since the last key press,
the display switches back from the additionally programmed values to the 1st value (room tempera
-
ture).
Adjusting the
slider switch
adjusts the
operating mode
of the heating circuit. The set operating mode
is indicated by a symbol:
Current room temperature in °C
and operating mode symbol
Current dew point in °C and op
-
erating mode symbol
Current relative room humidity
in % and operating mode sym
-
bol
Set value adjustment (only
when using the room sensor):
Using the rotary knob, the room
set temperature at the control
-
ler can be changed by +/- 4.0K.
This display indicates the size
of the change.
Current ambient air pressure in
mbar and operating mode sym
-
bol
