Your receiver will be switched on at the time when the selected programme is due to begin.
If the receiver is switched on by the timer, the letter "
t
" will be shown on the display, together
with the channel number. In this mode, most of the functions of the remote control are disab-
led in order to prevent an accidental premature interruption of the recording.
If the receiver is in standby mode, the activated timer will be indicated by blinking of the two
dots (colon) in the time display.
>
Press the Back key to return to the previous display.
D
Diissa
ab
blliin
ng
g tth
he
e ttiim
me
err ffu
un
nc
cttiio
on
n
If you want to cancel a timer command entered via the EPG, repeat the above steps, then
cancel the timer setting by pressing the
red function
key.
In order to interrupt/disable while the timer is actively in operation, switch off the receiver by
means of the
on/standby
key. When you press this key again, the receiver will be switched
on, and you can continue with normal operation.
6.13.7.4 EPG Survey
You can use the EPG Survey in order to display the current day's programme of a single
channel. This can be done as follows:
>
Press the
EPG
key.
The EPG table "
Now
" will be displayed.
Press the
green
function key.
The table
EPG Survey
will be displayed.
>
Use the
up/down
arrow keys to select the required programme resp. time.
>
If available, the
left/right
arrow keys can be used to display the programme con-
tents for the next few days.
D
Diissp
plla
ayyiin
ng
g E
EP
PG
G S
Su
um
mm
ma
arryy o
off o
otth
he
err C
Ch
ha
an
nn
ne
ellss
>
While the menu
EPG Summary
is being displayed, press the
green
function key.
A list of EPG channels will be displayed.
24
bed_anl_DigiBox Irdeto_englisch.qxd 30.01.02 12:03 Seite 24
