3
Setting up
Mounting
1.
Only use the device indoors, to protect it from lightning, rain and solar radiation. The device
should only be installed in rooms where the permitted ambient temperature range can be
maintained even when the climatic conditions change (excluding radiated heat and other
sources of heat).
2.
Choose the mounting location with regard to the minimum clearances to avoid a build-up of
heat; see Fig. 1.
3.
Mount the screws with d
max
=
4 mm and do not do them up tightly; see Fig. 2 and the attached
drilling template.
Fig. 1: Clearances to containing surfaces
Fig. 2: Dimensions and installation dimensions
4.
Install the equipotential bonding in accordance with the regulations (cable shoe).
5.
Suspend the BS5 Light and do the screws up tightly.
6.
Assembly the coax cable
1)
with the F compression connector as following:
Strip coax cabel.
Bend the outer braiding to the cable jacket
and the foil must be positioned smoothly to
the dielectric.
Insert cable to the connector (Art. no.
0001/3337) and compress with the
compression tool (Art. no. 0000/3339).
7.
Connect the HF connecting cables in accordance with the system planning.
8.
Close 3 drill holes in the cover plate by means of the enclosed caps
1)
If the cable inner conductor diameter is greater than 1.2 mm, or in the case of burrs, the device sockets may be damaged beyond
repair.
6,5mm 6,5mm
