Technika TEG64U, Инструкции по эксплуатации и монтажу

Страница: 21 / 32

21
INSTRUCTIONS FOR THE INSTALLER
Correct Chain Installation
In order to prevent the oven from tipping forward as
shown on the previous page, we need to make sure
both chains provided with the oven are used.
On the left side of the oven a 16mm drill bit was used to
drill through the cabinetry into the adjacent cabinet,
as you can see the hole has not been drilled hard
up against the wall because there is a 16mm board
at the rear of the cabinet. The height of the hole
from the floor is level with where the chain attaches
to the oven.
The right side has been drilled much the same,, a
new hole has been drilled below the gas and power
supply hole.
Once the holes have been drilled the chains can be fed
through and the upright can be fitted into position.
The chains then need to be pulled as tight as possible
from inside the cabinet while at the same time being
fixed to the rear of the cabinet using a self drilling
wood screw. It is better to have the screw fixed
closer to the hole for better support. The left and
right side examples shown have two extra screws
attached to the chain which makes the installation
neater by keeping the chain off the shelf away from
the gas and electricity supply, they will also provide
added support.
At this point the oven will be secured in location and
will not move forward at all, It is recommended that
all upright oven chains be fitted in this way.
Chain fixed in two
locations
Chain fixed in two
locations.
Anti-tilting chain/hose restraining chain
WARNING: Ensure the chains are correctly anchored to prevent the appliance from tilting forward and to prevent
strain on the hose when the cooker is pulled forward.
The cooker is supplied with two chains which are connected to the rear left and right of the appliance. The chains
should be connected to the wall directly behind the chains as low as possible to prevent the appliance from
tilting forward. The chains also prevent strain on the hose when the cooker is pulled forward. Ensure the chain
connections are strong enough to support the weight of the appliance.
Once the chains are installed, check that they prevent the appliance from tilting forward and that there is no strain
on the hose when the cooker is pulled as far forward as the chains allow.
If the cooker is INSTALLED between two cupboards you must drill a 16mm hole level to the safety chain height
on either cupboard as far back as possible, locate the cooker into position and pass the safety chains through
the 1 6mm holes, with the cooker in the final position pull both safety chains and secure them to the inside of the
cupboard with two screws on each safety chain.
Please test that the cooker does not tilt forward.