Technika T75E1200FL, Инструкция по эксплуатации

Страница: 10 / 17

Cleaning of the filter of the drainage pump
Cleaning of the machine
The machine cannot be cleaned by using hard substances like the solvent or steel wool and
etc., and it can be cleaned with a the soft cloth and light detergent .
Cleaning and Maintenance of the washing machine
Every time when the washing is finished, it is necessary to open the machine door, and mop
up the remaining water of the rubber seal ring, and to clean the dirt inside the seal fold in
time, in order to prevent any mildew and rot. To open the machine door slightly, to discharge
the humidity inside the barrel.
Please clean the drainage pump regularly to prevent the sundries blocking the drainage pipe.
Close the water tap
If necessary,wait until the water
Empty the water from the pump to a container cautiously . Screw the pump cover out and clean the filter
Install the pump cover
1 2
3
4 5
6
Pump cover
Note: make sure to pull out the power plug before the cleaning and maintenance.
！
1
2
Screw the inlet water pipe out.
Clean with the tool (like the gauze
brush and etc.)
Cleaning of the inlet water valve
If the inlet water time is found to be too long, please clean the filter net of the inlet valve.
If the machine cannot work normally or filter net of the drainage pump cannot be cleaned,
pleasefollow the method[1] below:
9
Routine maintenance
Disconnect the power plug
！
has cooled down
If the machine has the emergency drainage
Rotate the programme selector dial to OFF(stop) position and to close the water tap.
1
If necessary, wait until the water has cooled down. 2
Place a container on the floor, pull out the emergency emptying hose, place it into the container.
remove its cap and wait until the remaining water naturally flows out.
3
Emergency drainage pipe
Drainage pipe ferrule
If the machine has the emergency drainage, please follow the methods below when the
machine cannot work normally :
Open the filter's door
Turn the emergency
drain hose cap
Pull out the emergency
emptying hose
Remove the cap
！ ！
.If the machine doesn’t have Emergency drainage, please follow the methods[1] above .