Technicolor TG650S, Руководство по установке и эксплуатации

Страница: 48 / 114

42
3 CONFIGURATION TOOLS
DMS-CTC-20111123-0002 v1.0
Step 2: Setup the terminal connection
Proceed as follows:
1 Open your terminal.
2 Establish a connection with the following parameters:
 Baudrate: 115200 bits per second (bps)
 Data bits: 8
 Parity: None

Stop bits: 1
 Flow control: None
3 Make sure that your session does not interpret received data. This may cause problems when upgrading your
MediaAccess Gateway via the CLI. To avoid this use the following settings:
 Emulation: ANSIW
 Telnet terminal ID: VT100
3 You are now connected to the MediaAccess Gateway’s serial interface. The MediaAccess Gateway now waits for you to
enter your user name and password. For more information, see
“3.3.4 Using the CLI” on page 45 .
Traces
You can also use the CLI for tracing. The following types of traces are available:

Startup traces
When the MediaAccess Gateway starts up, it will send traces to the serial console allowing you to follow the boot process
of the MediaAccess Gateway. To view the startup traces, restart or power on your MediaAccess Gateway after setting up
the terminal connection.

Real-time traces
Press:
 CTRL+Q, to start displaying the real-time traces.
 CTRL+S, to stop displaying the real-time traces.
These are the defaults settings. You can change these settings via the CLI.
To access these setting on Microsoft HyperTerminal :
1 On the File menu, click Properties .
2 Click the Settings tab.